WARnInG! Always turn off the Welder and unplug the unit from its elec-
trical outlet prior to performing any assembly, maintenance, or service.
Insert the Handle (4) into the Handle Sockets (3). Then attach the Handle Sockets
to the center top of Side Panel (1), using the four Screws provided.
Attach the handle to the Face Shield by
lining up the two rectangular tabs on the
handle with the corresponding holes in the
face shield and
1) pressing it upwards
2) pressing it forward from the back,
locking the round tab in place.
See numbered steps in illustration to the
right.
1.
Lift the Access Panel (12) of the Welder to expose the Wire Feed Assembly.
2.
Unscrew and remove the Wing Nut (40) and Spool Knob (39).
3.
Install a 2 lb. Spool (not included) onto
the Wire Spool Axle (9), making sure
the Welding Wire unwinds from the top
(counterclockwise). Secure it to the shaft
using the spring underneath and the Knob
on top.
4.
Tighten the Knob (39) until only slight
resistance is felt when turning the Spool.
Then, tighten the Wing Nut (40) up against
the Knob.
For technical questions, please call 1-800-444-3353;
SKU 94164
ASSEMBLY InStRUCtIOnS
tO AttACh thE hAnDLE
FACE ShIELD ASSEMBLY
and then
tO InStALL A WIRE SpOOL
troubleshooting section at end of manual.
Round
Tab
Face
Shield
WELDInG
WIRE
SpOOL
WInG
nUt (40)
FIGURE C
Handle
SpOOL
KnOB (39)
Page 11