Sanyo VCC-WD8574 Instruction Manual page 43

M M M M
Select "ZOOM" and specify the zoom factor for
alarm detection.
• Select from: OFF (no zoom), x 1.4, x 2.0, x 2.5.
MEMO: • If you specify the "ZOOM" function, the center of the
screen will be electronically zoomed in automatically
when an alarm signal is supplied from external devices
such as door switch or infrared sensor, etc.
• Even though the "EL ZOOM" is already specified, the
"ZOOM" settings you configure here will override it.
Then "EL ZOOM" will be set to "OFF".
(See page 54)
• When "ZOOM" is set to "ON", the detection zone of the
motion sensor is limited to CENTER (initial position
and size).
When switching "ZOOM" back to "OFF", the above
setting will revert to those specified before "ZOOM"
was set to "ON". Also note that no adjustment is
possible for "BLC" – "CENT" if "ZOOM" is set to "ON".
• If "BLC" has been set to "CENT", the "ZOOM" function
will not work.
ALARM IN SETTING
MODE ALM
POLARITY NO
MOTION OFF
MOTION SET SET
ZOOM OFF
ZOOM TIME 5S
DURATION 5S
PRESET OFF
MENU BACK
Specifying Alarm Input
N N N N
Select "ZOOM TIME" and specify duration time
for zooming (if you specified "ZOOM" to other
than "OFF" in step M).
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M
(S = second, M = minute)
O O
O O
Select "DURATION" and specify a time until the
next alarm input becomes enabled.
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M
(S = second, M = minute)
Note: • When the "MODE" is specified with "COLOR", this
setting will not appear.
• When the alarm output starts, a new detection or an
alarm output cannot be performed until the specified
time of duration elapses.
P P
P P
Set "MENU" to "END" and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select "BACK" and
press the SET button.
MEMO: You can blink the camera name on the screen when an
alarm signal is supplied. (See page 45)
42
English