Eyepiece Assembly; Hand Control Holder Installation; Only) - SKY-WATCHER EQ6 Instruction Manual

EYEPIECE ASSEMBLY

Fig.15
INSERTING THE EYEPIECE (Fig.15, 16)
1) Unscrew the thumbscrews on the end of the focus
tube to remove the black plastic end-cap.
2) Insert the desired eyepiece and secure it by
retightening the thumbscrews.
EYEPIECE ASSEMBLY
Fig.17

HAND CONTROL HOLDER INSTALLATION

INSTALLING THE HAND CONTROL
HOLDER (Fig.18)
(for SynScan
Locate the hand control holder. Slide
the holder onto the accessory tray as
shown in Fig.6.
INSERTING THE EYEPIECE (Fig.17)
1) Loosen the thumbscrew on the end of the focus tube.
2) Insert the diagonal into the focus tube and re-tighten
the thumbscrew to hold the diagonal in place.
3) Loosen the thumbscrews on the diagonal.
4) Insert the desired eyepiece into diagonal and secure
by re-tightening the thumbscrews.
Fig.18
TM

only)

7
(for reflectors)
Fig.16
(for refractors)