Setting Up The Telephone For Use - Siemens Gigaset C28 Manual

/ English / A31008-A200-xxxx-x-xx19 /Ke
Gigaset
C28

Setting up the telephone for use

Step 1: Connecting the base
Connect the phone jack with the phone cord
and the mains units (220 V) with the power cord
as shown. Place the cords in the cord recesses.
The two cords must be plugged in at all times.
◆
Use only the mains unit supplied (see the bot-
tom of the base).
◆
If you ever purchase another phone cord from a
store, ensure that the phone conductors are cor-
rectly connected: 3-4 connection of the telephone
conductors/EURO CTR37.
Step 2: Setting up the handset
Fitting the battery pack
◆
Fit the plug into the socket.
◆
Insert the battery (see diagram below).
◆
Place the battery leads in the cable guides.
Closing the battery cover
Place the cover on the battery compartment as
shown in the diagram, then push it down until it
snaps into position.
ntucky
2
Opening the battery cover
Push the point show in the picture and lift it.
◆
Place the battery leads in the cable
guides so that the battery cover cannot
catch on the leads and damage them
when it is closed.
◆
Only insert the recommended re-
chargeable battery pack, i.e. never use a
normal battery pack as this could damage
your health and cause injury.
◆
Never use non-Siemens battery charg-
ers as this could damage the battery pack.
◆
Only place the handset in the base/
charging cradle that is intended for it.
Step 3: Registering the handset to the
base and charging the battery pack
Place your handset in the base with the display
facing forwards. The handset will now register
automatically to the base. For procedure see
page 4.
Charging the battery pack
To charge the battery pack, leave the handset in
the base for approx. 13 hours. The battery pack is
now fully charged. The charge status of the battery
pack is correctly displayed only after uninterrupted
charging/discharging. You should not therefore
interrupt the charging process.
Charging is electronically controlled to prevent
overcharging. The battery pack heats up during
charging; this is normal and not dangerous. After
a time the charge capacity of the pack will
decrease for technical reasons.
You must set the date and time to ensure that the
times of calls are logged correctly (page 8). Your
telephone is now ready to use.
Activating/deactivating the handset
Press the 'end call' key
If you place a deactivated handset in the base sta-
tion or charger, it will automatically activate.
Activating/deactivating the keypad lock
You can "lock" the keys on the handset to protect
the keypad against inadvertent activation.
To activate: press the hash key
The display shows the icon
To deactivate: press the hash key
The keypad lock deactivates automatically when
you receive a call and activates again after the call.
a
and hold.
R
and hold.
Ø
.
R
and hold.