Checking Power Trim And Tilt System - Yamaha DX150A Owner's Manual

w
EMU00993
CHECKING POWER TRIM AND TILT
SYSTEM
w
8 Never get under the lower unit while it
is tilted, even when the tilt-support
lever is locked. Severe injury could
occur if the outboard accidentally falls.
8 Make sure no one is under the out-
board before performing this test.
1) Check the power trim and tilt unit for
2) Operate each of the power trim and
q
3) Tilt up the motor and check that the
4) Use the tilt support lever 3 to lock the
e
5) Check that the tilt rod and trim rods
6) Activate the tilt-down switch until the
7) Activate the trim-up switch until the
8) Operate the motor to tilt down. Check
NOTE:
If any operation is abnormal, consult a
Yamaha dealer.
Recommended fluid;
4-18
any sign of oil leaks.
tilt switches on remote control and
engine bottom cowling (If equipped)
to check that all switches work.
tilt rod 1 and trim rods 2 are pushed
out completely.
motor in the UP position. Operate the
tilt down switch briefly so the motor is
supported the tilt support lever.
are free of corrosion or other flaws.
trim rods have gone completely into
the cylinders.
tilt rod is fully extended. Unlock the
tilt support lever.
that the tilt rod and trim rods operate
smoothly.
Yamaha power trim & tilt fluid or
ATF (DEXRON- II ).
E