Siemens Oven Installation Instructions Manual page 7

2.
Installation of the
build-in oven
To burn-in the insulation, heat up the oven
prior to installing the unit.
Push the built-in oven into the housing unit
and align the unit until it is in a level
position.
Open the oven door and, using one screw
on each side, fasten the built-in oven to the
side strips of the housing unit
(see illustration).
The two screws (supplied with the built-in
oven) must be started slightly outward.
Verify that the built-in oven is positioned
securely and in a level position, and that
the required installation dimensions have
been maintained.
The properly installed appliance must be
covered on all sides in such a fashion that
not even components with rough insulation
are exposed to the touch.
The cover must be removable with tools
only.
Kitchen furniture
Oven housing units from virtually all lines of
kitchen furniture are suitable for installing the
built-in oven.
However, the veneers or plastic laminates
on the housing unit must be applied with
heat-resistant glue (90 °C).
If plastic laminate or glue are not sufficiently
heat-resistant, warping, bubbling or
detachment of the finish may result.
7