Tool Kit; Removing And Installing The Shroud And Covers - Yamaha RX10RW Owner's Manual

E_8fp.book Page 5 Tuesday, March 28, 2006 4:35 PM
ESU03761

Tool kit

The owner's tool kit has the tools which are sufficient for
most periodic maintenance and minor repairs. A torque
wrench is also necessary to properly tighten nuts and
bolts.
1 Tool kit
CAUTION :
@
Before starting the engine, make sure that the tool
kit is properly seated in its holder and is securely
fastened.
@
NOTE:
@
If you do not have a torque wrench available during a
service operation requiring one, take your snowmobile to
a Yamaha dealer to check the torque settings and adjust
them if necessary.
@
ESU04502

Removing and installing the shroud and covers

Shroud
To remove the shroud
Turn the fasteners counterclockwise, slowly raise the
shroud, and then unhook the shroud from the shroud
stay.
1 Fastener
2 Shroud
To install the shroud
Hook the end of the shroud onto the shroud stay, slowly
lower it to its original position, and then turn the fasteners
clockwise.
1 Shroud stay
8-5