Yamaha SR230 Owner's/Operator's Manual page 38

No-Wake Mode can be engaged when
the throttles are at idle speed in
Forward, Neutral, or Reverse. Engine
speed will be set at 2,400 rpm for con-
venient, no-wake maneuvering.
To set No-Wake Mode:
Press both gray No-Wake Mode but-
tons simultaneously until the three
symbols in each tachometer start blink-
ing.
BILGE STEREO CTSY. LT. LIGHTS
5 6
7
4
3 RPM 8
x 1000
2 9
10
1
SE
11
NOTE: Although each engine is con-
trolled separately, always put both
engines in No-Wake Mode for proper
operation.
To cancel the No-Wake Mode, do any
of the following:
Press both No-Wake Mode buttons
again .
Move the accelerator levers to a faster
engine speed.
NO WAKE MODE
FOR OPERATING INSTRUCTIONS
CONSULT OWNERS MANUAL
HORN
40 45
35 50
MPH
5 6
30 4 7
55 RPM
3 8
20 x 1000
2 9
10 60
10
1
11
Features & Functions
Shut off the engines with the key or by
using the engine stop switch lanyard.
WARNING
Once the engines have stopped, you
have NO STEERING CONTROL over
the boat. You could collide with
another boat, a dock, or other obsta-
cle.
Accessory Outlet
There is a 12VDC outlet with resettable
circuit breaker located in the portside
console storage compartment.
Switch Circuit Breakers
The electrical circuit for each switch is
protected by a circuit breaker. If the but-
ton below a switch pops out, push it
back in with your finger. If it pops out
again, ask your Yamaha dealer to
inspect the electrical system.
BILGE STEREO CTSY. LT. LIGHTS
2-13
12 VDC
BREAKER
NO WAKE MODE
FOR OPERATING INSTRUCTIONS
CONSULT OWNERS MANUAL
HORN
2