Getting to know your appliance
An overview of the models with their dimensions is given on
page 2.
The control panel
Your controls are equipped with piezo technology. You operate
the symbol on the metal bar by pressing it lightly.
&RQWUROV IRU
WLPHU
Í GXDOFLUFXLW KRWSODWH
Controls
When you touch a symbol, the respective function is activated.
The hotplates
Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Dual-circuit hotplate, hotplate
â
with extended cooking zone
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the
#
main switch lights up. The hob is ready for use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
4
'LVSOD\V IRU
WLPHU
PDLQ VZLWFK
Activating and deactivating
Select the hotplate and touch the
Touch the
â
Touch the
â
symbol. The indicator above the
symbol until the display above the
Note: Bending or striking the metal panel, e.g. by knocking a
pot against it, may cause a malfunction.
'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW ¤
6HWWLQJV DUHD
IRU VHWWLQJ WKH KRWSODWH
IRU VHWWLQJ WKH WLPHU
© HOHFWURQLF ERLO VWDUW FRQWURO
symbol
ð
symbol; the 2nd filament circuit is activated.
symbol; the extended cooking zone is activated.
chocolate. As the hotplate cools down further, the display
changes to
cooled sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
Setting a hotplate
Set the required heat setting in the settings range.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
&RQWUROV IRU
KRWSODWH
k GXDOFLUFXLW KRWSODWH
ZLWK H[WHQGHG FRRNLQJ ]RQH
FRQWURO SDQHO SDXVH
. The display remains lit until the hotplate has
œ