To Attach The Mid-Section To The Body; To Attach The Power Switch Assembly And Variable Speed Adjustment; To Attach The Main Table - Central Machinery ROUTER WITH FULL SIZE TABLE 91130 Assembly And Operating Instructions Manual

To Attach The Mid-Section To The Body:

1. With assistance, place the Mid-Section of the Router Table on top of the Base.
(See Figure H.)
2. Align the two mounting holes at the bottom of each Support Leg (12B) with the
two mounting holes at each end of the Table (8A). (See Figure H.)
3. Insert a Square Head Screw (11B) upward through each of the two mounting
holes at both ends of the Table (8A) and through the two mounting holes in each
Support Leg (12B). Then secure the Mid-Section to the Body, using four Large
Lock Knobs (14B) and Large Washers (13B). (See Figure H.)
TABLE
(8A)
FIGURE H

To Attach The Power Switch Assembly And Variable Speed Adjustment:

1. Insert the Power Switch Assembly (9B) and Variable Speed Adjustment (28B)
into the mounting hole located on the left end of the Left Side Board (17B). Then
secure the Power Switch Assembly and Variable Speed Adjustment to the Left
Side Board, using Screws (15B), Washers (16B), and Plastic Lock Nuts (18B).
(See Figure I, next page.)

To Attach The Main Table:

1. Place four Corner Washers (19B) on the ends of the two Support Legs (12B),
and align the three mounting holes in each Corner Washer with the three mount-
ing holes at each end of the Support Legs. (See Figure J, next page.)
2. Place the Main Table (20B) on top of the four Corner Washers and two Support
Legs (12B), and align the eight mounting holes in the Main Table with the eight
SKU 91130 For technical questions, please call 1-800-444-3353.
SUPPORT LEG (12B)
LARGE LOCK KNOB
(14B)
LARGE WASHER
(13B)
SQUARE HEAD SCREW
(11B)
SUPPORT
SIDE VIEW
LEG
(12B)
Page 14