Storing Stations In Memory - JVC KS-LX200R Instructions Manual

Cassette receiver
Hide thumbs Also See for KS-LX200R:
Table of Contents

Advertisement

Available languages

Available languages

3
Tune into a station you want while
"MANU" is flashing.
Press
stations of higher frequencies.
Press 4
stations of lower frequencies.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for FM
and 9 kHz intervals for AM – MW/LW) until
you release the button.
When an FM stereo broadcast is hard to receive:
1
Press MODE ATT while listening to an FM stereo
broadcast (the STEREO indicator lights up while
receiving an FM stereo broadcast).
2
Press MO/
, while "MODE" is still on the display,
so that the MONO indicator lights up on the
display.
The sound you hear becomes monaural but the
reception will be improved (the STEREO indicator
goes off).
Each time you press the button, the MONO
indicator lights up and goes off alternately.
8
¢ to tune into
to tune into

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3.)
1
Select the FM band (FM1–3) you want
to store FM stations into.
1 Press SOURCE (BAND)
2 If necessary, press and
Each time you press and hold the button, the
FM band changes as follows:
FM1
2
Press and hold both buttons for more
than 2 seconds.
"SSM" appears, then disappears when automatic
preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3.)
These stations are preset in the number buttons —
No.1 (lowest frequency) to No.6 (highest frequency.)
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
to select FM as the
source.
hold SOURCE (BAND)
repeatedly to select the
FM band (FM1, FM2 or
FM3.)
FM2
FM3

Advertisement

Table of Contents
loading

Table of Contents