Makita GA7020 Instruction Manual page 6

ASSEMBLY
1. Wheel guard
2. Screw
3. Bearing box
4
1. Lock nut
2. Depressed center wheel
3. Super flange
4. Inner flange
6
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing side grip (handle)
006735
CAUTION:
• Always be sure that the side grip is installed securely before operation.
Screw the side grip securely on the position of the tool as shown in the figure.
Installing or removing wheel guard
006736
1
CAUTION:
• The wheel guard must be fitted on the tool so that the closed side of the
guard always points toward the operator.
Mount the wheel guard with the protrusion on the wheel guard band aligned
with the notch on the bearing box. Then rotate the wheel guard around 180
degrees counterclockwise. Be sure to tighten the screw securely.
2
3
To remove wheel guard, follow the installation procedure in reverse.
Installing or removing depressed center grinding
006746
wheel/Multi-disc (accessory)
1
Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange
2
and screw the lock nut onto the spindle.
3