Table of Contents
Advertisement
(Widescreen) — If you have a widescreen TV set,
16:9 WIDE
use this setting. The DVD plays in full size. (You must also
set your widescreen TV to "full size").
SELECTING DIGITAL AUDIO OUT
Each DVD has a variety of audio output options. If you
connected a Component to the receiver's digital optical jacks
(see "Connecting a Digital (Optical) Audio Component" on
Page 7), you might have to change the digital audio output
setting. Set the player's Digital Audio Output according to the
type of audio system you use.
1. Press
.
DVD SET UP
2. At the setup screen, press
3. Repeatedly press
ENTER
or
) , then press
BITSTREAM
— Select
BITSTREAM
or other equipment with DTS decoder or Dolby Digital
decoder connected to the receiver.
— Select
if you have an amplifier or other
PCM
PCM
equipment with linear PCM only (or a MD recorder or a
DAT deck) connected to the receiver.
C C C C a a a a u u u u t t t t i i i i o o o o n n n n : : : : If an active digital audio output signal is supplied to a
receiver or other equipment without a corresponding digital
decoding capability, a very loud noise might be produced
which could permanently damage your speakers.
N N N N o o o o t t t t e e e e : : : : When you make a digital recording from a CD to your
audio CD receiver, entire CD tracks are recorded as one track
because there is no track information.
or
to select
DIGITAL OUT
to select the desired output (
.
ENTER
if you have an amplifier
BITSTREAM
PCM
22
Advertisement
Table of Contents
