Troubleshooting - TECHWOOD DVR98 Quick Start Manual

TROUBLESHOOTING

To determine any problem with your receiver, always check the most obvious possible causes first. If any problem still remains
after your have checked the items below, consult your nearest TECHWOOD dealer.
Incorrect operation is often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and
electrical appliances being used.
Symptom
No power. The power cord is disconnected.
The power is on, but No disc is inserted.
the DVD player does
not work.
No picture. The TV is not set to receive DVD signal
output.
The video cable is not connected securely. Connect the video cable into the jacks securely.
The connected TV power is turned off.
The playback picture is The disc is dirty.
poor.
The DVD player does No disc is inserted.
not start playback.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
A menu is on the TV screen.
The rating level is set.
The remote control The remote control is not pointed at the
does not work remote sensor of the unit.
properly.
The remote control is too far from the
unit.
There is an obstacle in the path of the
remote control and the DVD player.
The remote's batteries are exhausted.
The receiver does not Static electricity caused by dry air.
respond when the
buttons are pressed.
No sound is output Improper connections
when a function is
Sound is muted.
selected.
The volume is turned down.
No image is output Improper connections.
when a function is
The input source is not properly selected. Press the correct function button.
selected.
Cause
Plug the power cord into the wall outlet securely.
Insert a disc. (Check that the DVD or audio CD indicator in
the DVD display is lit.)
Select the appropriate video input mode on the TV so the
picture from the DVD player appears on the TV screen.
Turn on the TV.
Clean the disc.
Insert a disc. (Check that the DVD or audio CD indicator in
the DVD display is lit.)
Insert a playable disc. (Check the disc type, color system
and regional code.)
Place the disc with the playback side down.
Place the disc on the disc tray correctly inside the guide.
Clean the disc.
Press
Cancel the rating function or change the rating level.
Point the remote control at the remote sensor of the unit.
Operate the remote control within about 23 feet (7 m).
Remove the obstacle.
Replace the batteries with new ones.
Disconnect the power plug from the outlet, and insert
again.
Make sure the component is connected correctly.
Press the remote's
Adjust
Make sure the component is connected correctly.
23
Remedy
to turn off the menu screen.
SETUP
.
MUTE
.
VOLUME