Functional Description; Specifications; Initial Tool Set Up/ Assembly; Air Supply - Central Pneumatic 66103 Set Up And Operating Instructions Manual

FUNCTIONAL DESCRIPTION

Specifications

Operating Air Pressure
Range
Maximum Air Pressure
Air Inlet
Air Consumption
Nozzle Size
Hopper Capacity
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
SKU 66103
25 - 90 PSI
90 PSI
1/4" -18 NPS
7 CFM @ 25 PSI
4 mm (5/32")
6 mm (15/64")
8 mm (5/16")
1.5 gal
For technical questions, please call 1-800-444-3353.

Air Supply

Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Note: The use of an in-line air and water
separator installed between the filter
and the regulator is recommended.
1. Attach an air hose to the compres-
sor's air outlet. Connect the air hose
to the air inlet of the tool. Other com-
ponents, such as a connector and
quick coupler, will make operation
more efficient, but are not required.
WARNING! TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL
OPERATION:
Do not install a female quick
coupler on the tool. Such a coupler
contains an air valve that will allow
the air tool to retain pressure and
TO PREVENT
EXPLOSION:
Page 7