Functional Description; Specifications; Initial Tool Set Up/Assembly; Air Supply - Central Pneumatic 99959 Set Up And Operating Instructions Manual

FunctionAl description

Specifications

Maximum Air Pressure
Air Inlet
Air Consumption
initiAl tool set up/
AssemBly
read the entire importAnt
sAFety inFormAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
unpacking
When unpacking, check to
make sure that the item is intact
and undamaged. if any parts
are missing or broken, please
call Harbor Freight tools at the
number shown throughout the
manual as soon as possible.
AssemBly
1. No assembly is required for this tool
with the exception of threading the
Flexible Supply Nozzle (1) onto the
Gun Assembly (2).
2. This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
SKU 99959
90 PSI
1/4" -18 NPT (Female)
4 SCFM @ 116 PSI
For technical questions, please call 1-800-444-3353.

Air supply

use only clean, dry, regulated,
compressed air to power this
tool. do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
1. Attach an air hose to the compres-
sor's air outlet. Connect the air hose
to the air inlet of the tool. Other com-
ponents, such as a connector and
quick coupler, will make operation
more efficient, but are not required.
2. WARNING! to prevent seri-
ous injury From AccidentAl
operAtion:
do not install a female quick cou-
pler on the tool. Such a coupler
contains an air valve that will allow
the air tool to retain pressure and op-
erate accidentally after the air supply
is disconnected.
to prevent
explosion:
Page 6