Subaru IMPREZA 2002 Owner's Manual page 342

1) "FULL" level mark
2) "LOW" level mark
WARNING
Never attempt to remove the radiator cap until
the engine has been shut off and has cooled
down completely. Since the coolant is under
pressure, you may suffer serious burns from a
spray of boiling hot coolant when the cap is
removed.
4. Slowly pour the coolant and fill to the radiator fill-
er neck and to the reserve tank's " FULL" level mark.
Do not pour the coolant too quickly, as this may lead
HGB001CB
to insufficient air bleeding and trapped air in the
system.
Coolant capacity:
Non-turbo models:
MT. 7.4 US qt (7.0 liters, 6.2 Imp qt)
AT. 7.3 US qt (6.9 liters, 6.1 Imp qt)
Turbo models:
MT. 8.1 US qt (7.7 liters, 6.8 Imp qt)
AT. 8.0 US qt (7.6 liters, 6.7 Imp qt)
1) Rubber gaskets
5. Put the radiator cap back on and tighten firmly. At
this time, make sure that the rubber gasket in the ra-
Maintenance and service
HG0115
– CONTINUED –
11-17