Subaru IMPREZA 2002 Owner's Manual page 314

1. Take out the towing eye, screwdriver and wheel
nut wrench from the on board tool bag.
2. Pry off the cover on the front bumper using a
screwdriver, and you will find a threaded hole for at-
taching the towing eye.
3. Screw the towing eye into the threaded hole until
its thread can no longer be seen.
4. Tighten the towing eye securely with a wheel nut
wrench.
After towing, remove the towing eye from the vehicle
and stow it in the tool bag. Put the threaded hole
cover on the front bumper.
WARNING
D Do not use the towing eye except when tow-
ing your vehicle.
D Be sure to remove the towing eye after tow-
ing. Leaving the towing eye mounted on the
vehicle could interfere with proper operation
of the SRS airbag system in a frontal collision.
Rear towing eye:
CAUTION
Do not apply excessive lateral load to the tow-
ing eyes.
In case of emergency
HG9004CA
– CONTINUED –
9-17