Table of Contents
Advertisement
uSer-Maintenance
inStructionS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
froM tooL faiLure:
do not use damaged
equipment. if abnormal noise,
vibration, or leaking air
occurs, have the problem
corrected before further use.
Motorcycle Lift does
1.
not lift
2.
3.
4.
Motorcycle Lift
1.
does not lower
Motorcycle Lift
1.
Fades (slowly
2.
lowers on its own)
3.
Oil leaks from top
1.
rod of Hydraulic
Ram (24).
Oil leaks from the
1.
pump and cylinder
follow all safety precautions whenever diagnosing or servicing the tool.
SKU 66305
for technical questions, please call 1-800-444-3353.
to preVent
SeriouS injury
troubleshooting
possible causes
Steel Ball (13a) in the Discharge
Valve or the single-way valve of
the Hydraulic Cylinder does not
seat or seal well.
Steel Ball (13a) in the Single-way
valve does not seat or seal well.
Hydraulic Ram may require
purging.
Discharge Valve is open.
Discharge Valve is not open
Leaking Valves or Seals.
Low on oil in system.
Hydraulic Cylinder may require
purging.
Ram O-ring (2a or 6a) is worn
out.
O-ring at pump (18a) or Oil Seal
(3a or 10a) is worn out.
cleaning Maintenance and
Lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
1.
Weekly - pivot point Lubrication
and Safety inspection:
Lubricate the pivot points of the tool,
using white lithium grease. Inspect for
loose fasteners or any damage to the
Lift. Repair immediately or mark "Out
of Service" until repairs are made.
2.
If the Hydraulic Ram fades or fails to
lift you may need to add oil or purge
the Ram.
Likely Solutions
1.
Clean or replace these components.
2.
Clean or replace these components.
3.
Purge Ram. See instructions on page 6.
4.
Tighten the discharge valve.
1.
Check function of Release Linkage Assembly
(54).
1.
Take to qualified repair technician for service
2.
Check oil level. Refill and purge as necessary.
Follow instructions for purging system.
3.
Purge Hydraulic Ram. See instructions on page 6.
1.
Replace the O-ring.
1.
Replace the O-ring or Oil Seal.
Page 11
Advertisement
Table of Contents
