Table of Contents
Advertisement
14.
When the motorcycle is lifted, be sure
that the Safety Bar (75) is slightly
above one of the ramps of the Inner
Scissor Arm (35).
15.
Press the Load Pedal (69) until the
Safety Bar (75) is fully engaged with
the ramp of the Inner Scissor Arm
(35). See Figure 4.
Locking Bolt (41)
Figure 4
16.
Once the motorcycle has been lifted,
do not move the Lift around. This Lift
is not designed to transport any load.
The Lift can be immobilized by turn-
ing the two Locking Bolts (41) clock-
wise firmly against the floor.
17.
Do not leave the motorcycle on the lift
unattended. If you plan to leave the
area, lower the lift and remove the
motorcycle before leaving.
18.
Do not use the Lift as a storage de-
vice.
19.
Pump the Pump Pedal (56) a few
times to remove weight from the
Safety Bar (75).
20.
Disengage the Safety Bar (75) from
the ramp of the Inner Scissor Arm
(35). Swing the Safety Bar up and
SKU 66305
for technical questions, please call 1-800-444-3353.
Inner
Scissor
Arm (35)
Safety Bar (75)
insert the Safety Bar Lock Pin (40)
into the hole in the upper axle of the
Safety Bar. This will lock the Safety
Bar in the upright position. See Fig-
ure 5.
Figure 5
21.
Press the Load Pedal (69) to GEN-
TLY lower the load. NEVER allow the
load to come down quickly or sud-
denly.
22.
With the load fully lowered, have a
helper hold the motorcycle. Remove
the tie down straps. Roll the motor-
cycle off the back of the Lift.
23.
Secure the motorcycle.
24.
Loosen the two Locking Bolts (41) by
turning a few turns counterclockwise.
25.
Roll the motorcycle lift to a secure
storage area out of the reach of chil-
dren.
26.
When work has been completed on
the motorcycle, clear all tools away
from the area.
Safety Bar Pin (40)
Page 10
Advertisement
Table of Contents
