Table of Contents
Advertisement
operating inStructionS
do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. improper
adjustment can result in tool
failure or other serious
hazards.
1.
Position the Lift in a safe and suitable
area as discussed above.
2.
Press the Load Pedal (69) to fully
lower the lift.
3.
Pull out the Ramp (1) and Pull Ramp
(8) as needed to accommodate the
length of the motorcycle.
4.
Be sure the Front Wheel Chock (17)
is rotated toward the rear of the Lift.
5.
Roll the motorcycle up the Ramp (1)
and onto the Deck Plate (16).
Front Wheel Rest (21)
Pull Pin (7)
Figure 3
6.
Roll the front wheel over the Front
Wheel Chock (17) and into the Wheel
SKU 66305
for technical questions, please call 1-800-444-3353.
to preVent
SeriouS injury:
Wheel Chock (17)
Wheel Lock Axle (19)
Rest (21). The Front Wheel Lock will
rotate with the wheel, supporting it
from the rear.
7.
The Wheel Chock (17) can be ad-
justed to fit your wheel. Remove the
Nut (18) from one end of the Wheel
Lock Axle (19), and slide the Axle out
of the Deck Plate (16). The Wheel
Lock can be moved as needed and
the Wheel Lock Axle inserted in the
appropriate holes in the Deck Plate.
Reinstall the Nut and tighten. See
Figure 3.
8.
With a helper holding the motorcycle
upright, secure the motorcycle to the
Lift using the Tie Down Points (13
and 31).
9.
Before lifting any motorcycle, it must
be securely fastened to the Lift us-
ing tie-down straps (not supplied) or
other suitable method. Two Front Tie
Down Brackets (13) and two Rear Tie
Down Brackets (31) are built into the
Lift for this purpose.
10.
Refer to the manufacturer's motorcy-
cle service manual for recommended
attachment points on the vehicle.
11.
There must not be hazardous ob-
jects (such as utility lines or foreign
objects) nearby that will present a
hazard while working.
12.
Before lifting the motorcycle, pull out
the Safety Bar Lock Pin (40) to allow
the Safety Bar (75) to rest on the In-
ner Scissor Arm (35).
13.
To Lift the motorcycle, pump the
Pump Pedal (56) repeatedly until
the motorcycle is lifted to the desired
height.
Page 9
Advertisement
Table of Contents
