Basic Specifications; Unpacking; Set Up Instructions; Assembly - Greyhound 56072 Set Up And Operating Instructions Manual

20 ton log splitter
Table of Contents

Advertisement

Basic speciFications

Hydraulic Jack Force
Hydraulic Fluid
Capacity
Hydraulic Fluid
Rotation
viewed from PTO
(power takeoff - the output shaft)
Maximum Log Size
Towing
Coupler Ball Required
Wheel Size
Tire Air Pressure
Supplied Accessories
note: Engine specifications are found in
the engine manual supplied with this
equipment.

unpacking

When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.

set up instructions

read the entire iMportant
saFety inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
SKU 56072
For technical questions, please call 1-800-444-3353.
20 Tons
8 Gallons
Anti-abrasion ISO
viscosity grade #46
Hydraulic Fluid. Change
every 100 hours of use.
Counterclockwise
25" Long x 12"
Diameter
For off-road use only
(not DOT approved)
2"
8-4.80/4.00
60 PSI (cold)
Hitch Coupler, Safety
Chain
FroM accidental
starting:
turn the power switch of the
equipment to its "oFF"
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
assembling or making any
adjustments to the equipment.
operate only with proper
spark arrestor installed.
operation of this equipment
may create sparks that
can start fires around dry
vegetation.
a spark arrestor may be
required.
the operator should contact
local fire agencies for laws
or regulations relating to fire
prevention requirements.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

assembly

packing the Bearings / Hub and Wheel
assembly.
1.
Whenever a hub is disassembled (if a
hub on a new unit requires assembly
or a hub is disassembled for main-
tenance), the following procedure
MUST be followed.
2.
Using a suitable solvent, clean the
bearings and the rest of the parts of
the Hub assembly. The parts must
to prevent
serious injury
to prevent
serious injury:
Page 7

Advertisement

Table of Contents
loading

Table of Contents

Save PDF