Data - Nike TRIAX 26 Manual

EN Manual FINAL (RunII) NEW
Reset a run
The chronograph must be stopped to reset a run.
Press and hold ADJUST/RESET for 2 seconds.
"HOLD RESET" flashes to reset current run. Time returns to zero.
NOTE: Over 100 hours, the run will be reset automatically.
Switch the primary display between lap and split time
In CHRONOGRAPH mode, press the ADJUST/RESET button.
Lap and split times will change between primary and
secondary position on the display.
Note that display settings in CHRONOGRAPH mode
are also reflected in DATA mode.
Check remaining memory capacity
When the chronograph is reset, press the STOP/NEXT button.
Lap memory capacity is displayed.
4/26/99 5:00 PM Page 8
8
b

DATA

In DATA mode you can
recall lap and split times
measurements from your
saved runs.
Cycle through the run numbers
Press the STOP/NEXT button.
Run number and date of run are displayed.
NOTE: If dashes appear in the display, no data
exists for that run.
Cycle by date through lap and split times, total time,
best time, and average time for each run
Press the START/LAP button.
A D J U S T/ R E S E T
M OD E
R U N N U M B E R
D AT E
9
S TA R T/ L A P
S TO P / N E X T
E L E C TR OL I TE