Appendix: Installing The Stand - Sanyo LED-32XR10FH Instruction Manual

Appendix: Installing the Stand or wall-mount bracket
If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV
on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of your ability to
do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or service personnel. The
manufacturer is not responsible for any damages or injuries that occur due to mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent accidental
scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can cause damage to
your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Table edge
Table edge
Installing a wall-mount bracket
(not provided)
Adhere two provided washiers to
upper two wall-mount holes, so that
four wall-mount holes can be even.
Two washiers
(provided)
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for comparative
purposes only.
To install the stand:
1. Remove the stand from the box and place it on a table or
You must pay attention to the direction of the stand. The wide
2. Lay your TV flat (screen down) on the edge of a table or
Stand column
Stand
3. Put the stand close to the TV back, align the stand with the
Secure with
four screws
To attach your TV to a wall-mount bracket (not provided)
1. Carefully place your TV screen face-down on a cushioned,
2. Remove the four screws holding the TV to its stand column.
3. Remove the stand column.
4. Secure the wall-mount bracket to the back of your TV using
Remove these screws
Note: There are two washiers provided for wall-mount. If
you want to wall mount the TV, please adhere these two
washiers to upper two wall-mount holes so that four wall-
mount holes can be even, thus to ensure wall-mount
reliability.
If you use pedestal stand for TV installation, please
retain these two washiers for future possible wall-
mount use.
bench.
portion of the stand should go towards the front of the TV.
bench. Make sure that you put down a soft cushion or cloth so
that your TV is not scratched.
stand column by moving the stand steadily, and align the screw
holes on the stand column with the holes in the stand, then
secure the stand to the TV with provided screws .
To remove the stand from the TV, perform these steps
in reverse order.
clean surface to protect the screen from damages and
scratches.
the four screws provided with the bracket.
37