First Time Configuration/Basic Operations - Sanyo LED-32XR10FH Instruction Manual

First Time Configuration/Basic Operations

Turning on your TV for the first time
To use this TV for displaying in a store, please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended for normal home use.
Standard/Energy Save
Select
OSD Language
Channel Tuning
14
Turning the TV on or off
Energy Save Mode
Store/Dynamic
OK
OK
Installation Guide
English
Start Exit
OK Exit
Channel Tuning
2 %... 78.50MHz ATV
ATV : 2 Programme(s)
: 0
DTV Programme(s)
Radio : 0 Programme(s)
Press <Menu> to skip.
Press <Exit> to exit.
To turn the TV on or off:
1
Plug the power cord into an AC power outlet. Press Power Switch on the TV.
Now the set is in standby mode. Wait some seconds until the power indicator lights
2
up, then press POWER
pressing POWER button. If you promptly press POWER button then the TV may not
Power Switch
respond or act wrongly.)
3
Press button again to turn off the TV and put the TV in standby mode.
To cut off the power completely, press Power Switch on the TV.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of
energy saving and safety issue, please press Power Switch to completely cut off the power.
After you turn off the TV, you should wait at least 5 seconds (the power indicator goes
out)before you turn it on again.
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into
standby mode.
The first time you use the TV, you need to configure
your TV:
To configure your TV:
1
Make sure that you have inserted the batteries in the
remote control, have connected your antenna to the
TV, and have connected the AC power.
2
Press the Power Switch on the TV.
3
Press POWER to turn on the TV. After a few
seconds the Energy Save Mode screen opens.
4
Press 3
or4 to select Standard/Energy Save or
Store/Dynamic, press OK to confirm. (For normal
home use, please select Standard/Energy Save.)
5
Now the Installation Guide screen appears with
Channel Tuning highlighted. Press OK to begin the
auto tuning for all available ATV/DTV channels. It may
take several minutes, please wait until it is finished.
During searching, the screen will display a report
about found stations.
When complete, it will go to digital programme
position one. Now channel list has been created and
you can start to watch TV.
to turn on the TV. (Be sure to wait some seconds before