Appendix: Installing The Stand - Sanyo LED-22XR10F Instruction Manual

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV
on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of your ability to do this,
or of your ability to use the tools necessary to complete this job, refer to a professional installer or service personnel. The manufacturer is not
responsible for any damages or injuries that occur due to mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent accidental scratching or
damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can cause damage to your TV
that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Locators on
the stand column
3. Put the stand close to the TV back, move the stand gently until the locators on the stand column align with the locating
grooves on the stand, and align the screw holes on the stand column with the holes in the stand, then secure the stand to
the TV with provided screws .
To remove the stand from the TV, perform these steps in reverse order.
Adjusting the viewing angle
Forward Backward
Installing a wall-mount bracket
(not provided)
NOTE:
The appearance of this product in
these illustrations may differ from
your actual product, and is for
comparative purposes only.

Appendix: Installing the Stand

To install the stand:
1. Remove the stand from the box and place it on a table or bench.
2. Lay your TV flat (screen down) on the edge of a table or bench.
Secure with
Locating grooves
three screws
To adjust the viewing angle:
! Tilt the screen forward or backward.
Caution: When adjusting the viewing angle, be careful not to tip over
your TV.
Note: To avoid interference between the jacks, wall-
mount bracket, and wall, the wall-mount bracket must
be more than 40 mm thick, and the RF or VGA cable
must have a 90-degree plug.
To attach your TV to a wall-mount bracket (not provided)
1. Carefully place your TV screen face-down on a cushioned, clean
surface to protect the screen from damages and scratches.
2. Remove the screws holding the TV to its stand and remove the
stand.
3. Remove the stand column.
4. Secure the wall-mount bracket to the back of your TV using the four
screws provided with the bracket.
You must pay attention to the direction of the stand. The wide
portion of the stand should go towards the front of the TV.
Make sure that you put down a soft cushion or cloth so that your
TV is not scratched.
37