Operating Instructions; Setting The Clock - Sanyo DMP-P8 Instruction Manual

Operating Instructions

Make sure the AC power cord from this unit is properly connected to
a 240V 50Hz household AC power outlet.
Make sure the AC power cord from this unit is properly connected to
a 240V 50Hz household AC power outlet.
І) Setting the Clock
1) While the unit is at STANDBY
mode, press and hold MODE
button on the top panel or the
remote control for 2 sec. to
enter Clock set mode. "12H"
will show and flash on the display indicating that the clock is set to
12 hour format.
2) Press TUNE/SKIP button on the
top panel or remote control
once to change the clock format
to 24 hour time. The display will
change from "12H" to "24H" .
3) Press the MODE button to confirm.
The hour digit will begin flashing.
Press TUNE/SKIP button on the top
panel or remote control to set the
hour. Press MODE button to
confirm.
4) While hour is confirmed, minute
digit will begin flashing. Press
TUNE/SKIP button on the top panel
or remote control to set the minute.
Press MODE button to confirm.
- 9 -