Receiver Section; Audio Section; Specifications - Sanyo DMP-P7 Instruction Manual

Symptom
iPod didn't charge up
AM
No band radio sound
but others OK
AM
band radio is very
noisy
Sound is distorted
Remote Control didn't work
Unit gets warm after
extended play at high
volume
Can't hear speakers
attached to aux out jack
GENERAL
Power requirement
Power consumption
Dimension

RECEIVER SECTION

Receiving bands
Tuning range

AUDIO SECTION

Power output
Speaker impedance
AUX input sensitivity
ACCESSORIES
Power AC cord
Instruction Manual
Insert
Remote Control handset with battery
AM loop antenna
Patch card
3.5 & 3.5mm plug cable
Specifications subject to change without notice.
Troubleshooting
Possible Problem
iPod is not installed properly
iPod is locked up/frozen
AM
loop antenna is not
connected to the unit
AM
loop antenna isn't
located properly
Volume level is set too high
Sound source is distorted
Battery weak
Remote Control is not pointed
clock radio
toward to the
This is normal
Speakers lack power source

SPECIFICATIONS

AC 240V ~ 50Hz
DC 3V "AA" size/UM-3 x 2 pcs for Tuner MEMORY back up
DC CR2025 3V lithium battery for Remote control handset
AC 18 Watts
Unit 206 (W) x 195 (D) x 85 (H)mm
AM/FM
AM 522 - 1620KHz, 9KHz/STEP
FM 87.5 - 108MHz, 50KHz/STEP
2 Watts per channel
4 ohms
1000 mV
1 PC
1 PC
3 PC
1 PC
1 PC
1 PC
1 PC
Solution
Remove your iPod from the dock and check for
obstruction on the connectors in the dock and
on your iPod. Then reseat it in the dock.
Please make sure your iPod is working
properly before docking into the unit.
Please refer to your iPod manual for details.
AM
Plug the loop antenna connector to the
jack on the back of the unit
AM
Move the loop antenna away from the
main unit and rotate it for best reception
Decrease the volume
If the iPod original sound source (MP3) is of poor
quality, distortion and noise are easily noticed
with high-power speakers. Try a different audio
source such as a music CD, (via the aux socket).
Replace current battery with new battery
Point the Remote Control toward the
radio
, move within 10 feet of the unit.
Turn unit off for a while or lower volume
The signal from the aux out jack needs
amplification. Use powered speakers/
monitors or other amplified audio device.
14
clock