Storing Preset Stations; Recalling Preset Station; Alarm Operation - Sanyo DMP-P7 Instruction Manual

The unit enables you to program 10 stations of FM and 10 stations of AM band.
1. Press the SKIP FORWARD or BACKWARD Button on the clock radio (or
control) to tune to the station you wish to store.
2.
Press the PROG Button once on the remote.
3. Press the PRESET Button repeatedly on remote to select a preset number to store the station.
4. Press the PROG Button again to store station in chosen preset.

RECALLING PRESET STATION

Press the PRESET Button on remote control repeatedly to select the desired station.
NOTE: TO WAKE TO iPOD, YOUR iPOD MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE)
OR NO ALARM WILL SOUND.
Set the alarm time per Setting Alarm time. To preview the alarm time, just press the ALARM 1 Button or
1.
ALARM 2 Button once.
2. You can change the sound mode you wish to wake to at any time by pressing the WAKE Button.
3. Press the ALARM 1 Button or ALARM 2 Button again to arm or disarm the alarm.
4. When the alarm is sounding, press the POWER Button on the clock radio (or POWER ON/OFF Button on
the remote control) to turn the alarm OFF. The alarm will come on again the next day at the same time.
5. To stop the alarm from coming on the following day, press the ALARM 1 Button or ALARM 2 Button to turn
it OFF. The Alarm Icon and Wake Icon will disappear to indicate the alarm is disarmed.
If the alarm is not turned off after it sounds it will play for approximately 1 hour then turn off automatically.
6. This cycle will repeat every 24 hours unless the controls are changed.
Note: When you select Wake To iPod, please make sure your iPod has enough songs to play for 1 hour,
otherwise please set the iPod repeat mode to ON.
Note: If you select Wake To iPod but no iPod is present or there is no music on the iPod at alarm time, the clock
radio will automatically switch to buzzer alarm.

Storing preset stations

Alarm Operation

11
or Button on the remote