Sanyo DC-HT818 Instruction Manual page 20

Basic Playback
USB DRIVE AND MEMORY CARD PLAYBACK
Insert a USB drive in the USB port, then press [USB/SD] to enter the
connected USB drive and you can playback the readable files in it. Press
[USB/SD] again to switch back to DVD mode.
Insert an SD card into the memory card slot, then press [USB/SD] to access
the connected memory card and you can playback the readable files in it.
Press [USB/SD] again to return to DVD mode.
NOTE:
In case the player breaks down when you insert a USB drive or a memory
card into the player, turn off the player, disconnect the power cord from the
AC outlet and unplug the USB drive or/and the memory card from the player.
Then, power on the player again. The player will resume the normal status.
For playback operation, please refer to MP3 DISC PLAYBACK in this chapter.
If a USB drive and a memory card are inserted in the player at the same
time, press [USB/SD] once to select USB and press it twice to select the
memory card. Press it for the third time to return to the DVD mode.
The USB and SD function is only available under DVD mode.
USB MEMORY DEVICE OPERATION
- Copyright protection files cannot be played back.
- Copyright protection files on the USB memory
device are skipped automatically when played
back.
- Recommended use:
Flash memory type USB memory player
- Not recommended:
Hard disc memory type USB player
- Some Flash memory player will not play
successfully with this uint.
- Copyright protection files cannot be
played back.
- Copyright protection files on SD/MMC
card are skipped automatically when
played back.
IMPORTANT INFORMATIONS
SD CARD OPERATION
IMPORTANT INFORMATIONS
-19-