Last Memory - Sanyo DC-HT818 Instruction Manual

System Setup

1.6 LAST MEMORY

ON: During playback or in the paused/stopped status each time you open the disc tray
or turn off the player, the unit will memorize the last playback time. Next time when you
insert the same disc and close the disc tray to load the disc, the unit will play from the
memorized point.
OFF: Disable the last memory function.
2 AUDIO SETUP PAGE
2.1 ANALOG AUDIO SETUP
2.1.1 DOWNMIX
LT/RT: The 5.1-channel audio is mixed into left channel and right channel and is
output via the FL and FR speakers respectively.
STEREO: The 5.1-channel audio is mixed into stereo signal and is output via the FL
and FR speakers.
3D SURROUND: This mode creates a virtual surround effect from stereo or multi-
channel audio contents.
5.1CH: Turn off the DOWNMIX mode. If the unit is connected to a 5.1-channel
amplifier, this item should be selected.
NOTE: This function only applies to the Dolby AC -3 encoded 5.1-channel discs.
2.1.2 FRONT, CENTER, REAR SPEAKER and SUBWOOFER
Only when the DOWNMIX mode is turned off (DOWNMIX is set to 5.1CH) are the
CENTER SPEAKER and REAR SPEAKER activated. The FRONT SPEAKER can be
set to LARGE or SMALL. The CENTER SPEAKER, REAR SPEAKER can be set to
LARGE, SMALL or OFF and the SUBWOOFER can be set to ON or OFF.
NOTE:
If the speaker is set to LARGE, the output level will be higher than that of SMALL.
If the speaker is set to SMALL, the output level will be lower than that of LARGE.
If a speaker is set to OFF, no audio is output from it.
2.1.3 DIALOG
When DOWNMIX is set to LT/RT or STEREO, this item is available.
Adjust the value of this item to control the dialog volume.
NOTE: When playing 5.1CH disc, this item can be used to adjust the volume of the
speakers.
2.1.4 D.R.C. (Dynamic Range Control)
You can set this item to AUTO, ON or OFF.
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT
SPDIF/OFF: There will be no digital audio signal output. (Coaxial off)
SPDIF/RAW: The digital audio signal output will be in its raw format. Normally, this
mode is used for DTS & Dolby Digital 5.1 signals.
SPDIF/PCM: The digital audio signal output will be in PCM format. Normally, this
mode is used for audio CD signals.
-12-