Cleaning The Rgb Panels - Sanyo PLV-Z3 Owner's Manual

Maintenance and Cleaning

Cleaning the RGB panels

If some dusts attach to optical parts inside the projector, the brightness could decrease or shadows could
appear on the screen and image deterioration could result.
This projector equipped with RGB panel cleaning holes on the bottom of the projector to clean the internal parts
(such as optical parts) of the projector. When you use the projector continuously for hours or you find shadows
of dust on the projected screen, clean the inside of the projector with the supplied blower.
Using the supplied blower and the Cleaning function in the Setting menu, you can blow dusts away in the
projector.
NOTE
●
The dust might not be taken away completely with these steps. In that case, contact the dealer where you purchased the projector or
the service center.
CAUTION IN USING THE BLOWER AND THE NOZZLE
● When using the blower, turn over the projector.
● Use only supplied blower and nozzle to keep the projector from being out of oder or damaging . We
CAUTION
● Do not use a commercially available air spry not to cause malfunction of internal parts with the cool air.
● Put the projector on a soft cloth not to scratch the surface.
● Open the hole cover only when you clean the inside of the projector.
PROHIBITED
● Do not pull the hole cover strongly.
● Do not look into the holes. Strong light could damage your eyes. (Do not look into Air intake vent and
● Use the blower and the nozzle only to clean the projector. Do not try to use them to another purpose.
● Do not try to pull the nozzle out from the blower. If the nozzle happened to pull off, put it back into the
When you find something unusual (smoke, strange sound, abnormal odor and so on) while you are cleaning, turn
off and unplug the projector immediately, then call the dealer you purchased it or service center.
If the nozzle pulled off.....
The nozzle has stoppers. Put the stopper side of the nozzle in the
blower. Put the nozzle firmly in the blower until the stoppers become
invisible.
When putting the nozzle in the blower, hold the stopper side not to
break the nozzle.
Make sure not to force the nozzle to pull off from the blower.
46
could not guarantee the malfunction or breakage caused by using unsupplied tools.
Exhaust vent, either.)
Do not use the blower and nozzle to a man (especially eyes, mouth or ear and so on). Be careful
not children put the blower and nozzle into their mouths or swallow them.
blower.
Pull the nozzle in
the blower this way
Pull the nozzle in
till the stopper
become invisible
Stopper
Hold the stopper
side of the nozzle