Side Terminal - Sanyo PDG-DXL2000 Owner's Manual

S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.17).
VIDEO IN
Connect the composite video output signal to this
jack (p.17).
AUDIO IN
Connect the audio output signal from video
equipment connected to
a monaural audio signal (a single audio jack),
connect it to the L (MONO) jack (p.17).
COMPUTER 1/COMPONENT AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to
jack (pp.16, 18).
COMPUTER 2 AUDIO IN
Connect the audio output (stereo) from a computer
connected to to this jack (pp.16, 18).
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.16-18).
This terminal outputs sound from AUDIO IN
terminal ( , or ) or HDMI terminal
audio).
CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.

Side Terminal

or to this jack. For
or to this
(digital
Part Names and Functions
3D SYNC OUT
Connect a 3D sync. signal cable for an IR wireless
emitter to this jack (p.48)
LAN Connection Terminal
Connect the LAN cable (refer to the owner's
manual of "Network Set-up and Operation").
COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.16, 18).
COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used
for input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
16, 56)].
HDMI
Connect the HDMI signal from computer or video
equipment to this terminal (pp.16, 18).
11