Cub Cadet CC25GHT Operator's Manual page 14

MAINTENANCE AND REPAIR INSTRUCTIONS
FUEL CAP / FUEL FILTER
CAUTION:
container before starting this procedure. Open
fuel cap slowly to release any pressure which
may have formed in fuel tank.
Fuel Filter:
1. Completely remove fuel cap (A) from fuel tank (B) to
be able to remove fuel filter (D) from tank. Use a
piece of wire (C) with a hook formed at the end to pull
filter out of tank. (Figure 15 & Figure 16)
2. Pull filter (D) off with a twisting motion.
3. Replace fuel filter (D). (Figure 17)
NOTE: Never operate the hedge trimmer without the fuel
filter. Internal engine damage could result!
Remove fuel from unit
and store in approved
A
Fig. 15
C
B
Fig. 16
D
Fig. 17
IDLE ADJUSTMENT
The carburetor was pre-set at the factory for optimum
performance. If further adjustments are necessary take
your hedge trimmer to a Cub Cadet or other qualified
service dealer.
SPARK PLUG
1. To remove spark plug (B) (Fig. 19) for cleaning or
replacement: make sure engine is off, spark plug is
cool, then grasp spark plug boot firmly and remove
from spark plug. Remove spark plug with correct
spark plug tool. Inspect, clean or replace as needed.
2. Spark plug gap = .025" (.635mm) (Figure 18).
3. Torque to 120 inch pounds (12 to 15 N•m). Connect
spark plug boot.
4. If needed, replace spark plug with spark plug RDJ7Y
or equivalent.
.025" (.635mm)
Spark
Plug
B
14
Fig. 18
Fig. 19