Speaker Installation Option; Troubleshooting Guide - Panasonic SC-XH170 Operating Instructions Manual

Speaker installation option

Attaching to a wall
You can attach all of the speakers (except subwoofer) to
a wall.
≥The wall or pillar on which the speakers are to be
attached should be capable of supporting 10 kg per
screw. Consult a qualified building contractor when
attaching the speakers to a wall. Improper attachment
may result in damage to the wall and speakers, and
personal injury.
1 Drive a screw (not supplied) into the wall.
4.0 mm
‰
Wall or pillar
2 Fit the speaker securely onto the screw(s) with the
hole(s).
e.g., Surround speaker
DO NOT
≥In this position, the
speaker will likely fall if
moved to the left or right.
∫ Tips
Use the measurements indicated below to identify the
screwing positions on the wall.
≥Leave at least 20 mm of space above the speaker and
10 mm on each side to allow enough space for fitting
the speaker.
Front/Surround speaker
A 24 mm
B 116 mm
C 40 mm
D 40 mm
22
At least 30 mm
7.0 mm to 9.4 mm
‰ ‰
5.5 mm to 7.5 mm
DO
≥Move the speaker so
that the screw is in this
position.
Center speaker
E 18 mm
F 65 mm
G 24 mm
H 95.5 mm
I 27 mm
∫ To prevent speakers from falling
Front speaker, Surround speaker, Center speaker
e.g. Front speaker
String (not supplied)
Less than
10 cm

Troubleshooting guide

Before requesting service, make the following checks. If
you are in doubt about some of the check points, or if the
solutions indicated in the following guide do not solve the
problem, consult your dealer for instructions.
Power
No power.
Insert the AC mains lead securely. (
The unit is automatically switched to standby mode.
≥The Sleep timer was working and had reached the set
time limit. ( 4)
≥This unit will automatically switch to standby mode after
30 minutes of inactivity. (
This unit is turned off when the input for the TV is
changed.
This is normal when using VIERA Link "HDAVI Control 4
or later". For details please read the operating
instructions for the TV.
General operation
No response when any buttons are pressed.
≥This unit cannot play discs other than the ones listed in
these operating instructions. (
≥The unit may not be operating properly due to lightning,
static electricity or some other external factor. Turn the
unit off and then back on. Alternatively, turn the unit off,
disconnect the AC mains lead, and then reconnect it.
≥Condensation has formed. Wait 1 to 2 hours for it to
evaporate.
No response when remote control buttons are
pressed.
≥Check that the battery is installed correctly. (
≥The battery is depleted. Replace it with a new one.
( 8)
≥Aim the remote control at the remote control signal
sensor and operate. (
Other products respond to the remote control.
Change the remote control operating mode. (
Cannot display the START menu.
Remove the disc and then press [START]B again.
Screw eye
(not supplied)
Wall
8)
4)
20)
8)
4)
4)