Table of Contents
Advertisement
Sending a Fax by Automatic Dialling
Redial
You can automatically redial the last number dialled. This procedure can be
used to send a fax or make a phone call.
1
If you are sending a fax, load the
document(s).
If desired, press
resolution and/or contrast.
2
Press
number dialled. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press
begins.
If you are making a phone call, lift the handset. Dialling begins.
Note:
If a fax transmission is unsuccessful and DOCUMENT JAMMED appears in
the display, remove the document as explained on page 84. (This may occur if
the other fax machine doesn't respond properly when you attempt to send the
document.)
Automatic redialling
If you use automatic dialling (including Direct Keypad Dialling) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at an interval of five minutes.
During this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
54
RESOLUTION/
RECEPTION MODE
to set the
once. <REDIAL> appears in the display, followed by the last
START/MEMORY
. Dialling and transmission
READY TO SEND
Advertisement
Table of Contents
