Inspection, Maintenance, And Cleaning - Central Machinery 95346 Assembly And Operation Instructions Manual

INSPEctION, MAINtENANcE, AND cLEANING

1. WARNING! Remove the Spark Plug (51) and allow the engine to cool completely
prior to performing any service, maintenance, or cleaning of the Auger Drill.
2. before each use:
alignment or binding of moving parts, cracked or broken parts, dull or damaged
Auger (33a), and any other condition that may affect the safe operation of the tool.
If abnormal noise or vibration occurs, have the problem corrected before further
use. Do not use damaged equipment.
3. Auger (33a) maintenance:
debris can cause possible personal injury. Replace a damaged Auger and keep
the Auger clean at all times.
Spark Plug (51) maintenance:
4.
every six months or 100 hours of tool use. If necessary, clean or replace the Spark
Plug. The recommended Spark Plug replacement type is: "L7t".
5. Air filter (78) maintenance:
the Auger Drill for excessive dirt and debris buildup. Thereafter, the Air Filter should
be cleaned or replaced every three months or 50 hours of tool use.
6. Gearbox (8a) maintenance:
of the Auger Drill for proper quantity. If necessary, fill the Gearbox with SAE 80-90
weight gear oil. The Gearbox should be filled with clean, new gear oil every three
months or 50 hours of tool use.
7. to clean the Auger Drill:
terior of the Engine. Do not use solvents. Use a garden hose to clean the Auger
(33a). Do not introduce liquids into the interior of the Engine.
8. When storing the Auger Drill:
Tank (89). If this is not followed, old fuel in the Fuel Tank may clog the Carburetor
and prevent the tool from starting until cleaned out. Then store the tool in a clean,
dry, safe location out of reach of children and other unauthorized people.
9. cAUtION! All maintenance, service or repairs not mentioned in this
manual must only be performed by a qualified service technician.
SKU 95346 for technical questions, please call 1-800-444-3353
Inspect the general condition of the Auger Drill. Check mis-
An Auger that is bent or filled with excessive dirt and
The condition of the Spark Plug should be checked
The Air Filter should be checked prior to each use of
The Gearbox should be checked prior to each use
Use a clean cloth and a mild detergent to clean the ex-
Before storing, drain all fuel out of the tool's Fuel
PAGE 12