How to use the SBP-4442 KIT
How to charge the SBP-4442
Charging the battery with AC charger (24-pin)
1. Put the AC charger into your power socket.
2. Connect the AC charger and the SBP-4442.
If there is an error while the battery is charged, charging LED will be off or orange
coloured LED will brink. Check the connection again.
When the battery is charged completely, green LED of the AC adapter will be on.
- Using the AC charger : About 360 Min.
How to use the SBP-4442
Checking the SBP-4442 charging status
1. Press the Power button to turn on the SBP-4442 and you can check the charging status.
2. Press the Power button lightly and the charging status will be displayed.
3. Press the Power button for over 2 seconds and the SBP-4442 will be turned off.
Power button Discharging
Using the SBP-4442
- Insert the supplied DC cable for charging the SBP-4442 into the DC output terminal.
Turn on the SBP-4442 and you can use the SBP-4442 as a reserved battery for camera,
mobile phone, etc.
- You can use the SBP-4442 with a device that has 24-pin port.
Using with a digital camera and
Using and Charging the SBP-4442
at the same time
Do not charge and use the battery with a device at the same time. The device may not
be used because of the low battery capacity.
When you charge a device with the SBP-4442, the charging time may vary depending
on the device type.
An FCC warning
This device has been tested in accordance with the limits of a class B digital device
under item 15 of the FCC rules. These limits are designed to provide protection
against harmful interference in commercial installation. This equipment generates,
absorbs and can emit radio frequency energy. If it is not installed and used in
accordance with the instructions, it may cause harmful interference to radio
There is however, no guarantee that interference will not occur in some situations.
Should any interference occur when this device is in operation, please try one or
more of the following measures.
Change the location and direction of any aerial.
Increase distance between the camera and the affected device.
Use a different socket away from the affected device.
Please contact a Samsung agent or a radio/TV engineer.
This device complies with part 15 of the FCC Rules.
Changes or modifications not expressly approved by the party responsible for
compliance could void user's authority to operate the equipment.
Thank you for buying an SBP-4442.
This manual will guide you through using the SBP-4442.
Please read this manual carefully before using the SBP-4442.
Keep this manual in a place where you can use it easily.
SBP-4442 can be used for the following.
If there is low battery
If there is low battery
capacity during using
using a Samsung
portable devices, like a
Digital camera, you can use the
mobile phone, you can use
SBP-4442 for the reserved
the SBP-4442 for the reserved
Before using this KIT
Prior to using this KIT, please read the user manual thoroughly.
Keep the manual in a safe place.
You can charge the