Install The Validation Plate; Load The Film - Polaroid ID100 User Manual

Install the Validation Plate

The validation plate determines the location of the portrait on the
ID card. The validation plate may include a validating signature
or seal for additional security. Contact your Polaroid dealer or
representative for details and ordering information.
1
Open the film door.
2
Hold the validation plate by
the bottom tab.
3
Insert the top end of the plate so
the center tab fits under, and the
side tabs fit over the center rod.
The slot in the center tab
engages a pin inside the holder.
4
Move the plate from side to side.
If inserted correctly, it should
only move slightly.
5
Insert the bottom of the plate
into the holder so the bar pushes
in the spring.
6
Push in and down until the plate snaps into place.
To Remove the Plate
Grasp the sides of the plate near the bottom edge, and lift the
plate up and out.

Load the Film

The ID-100 Systems use Polaroid instant color films, such as:
Polacolor 100 ID UV film
Polacolor ID Ultraviolet (U.S.A. only)
Polacolor T681
IdentiFilm
Polacolor ER type 669
Each film pack produces ten 8 3/4 in x 4 1/4 in (8.5 cm x 10.8 cm)
sheets. The camera produces two ID card photographs on each
sheet (20 ID cards/pack).
Before loading film, check that the developer rollers are clean. See
the section Clean the Developer Rollers .
1
Open the film door.
2
Hold the film pack by the edges
and slide it in at an angle. Then
push it down into place.
3
Check that the white leader tabs
are not caught between the pack
and the holder.
4
Close and latch the door with
the black tab sticking out.
5
Pull the black safety cover
straight, all the way out of the
holder. A white leader tab
appears. If not, see the
section No leader tab ?
3