Timer Programming - Panasonic Viera TX-L32X5B Operating Instructions Manual

Timer Programming

Timer Programming from Menu
The Timer Programming menu allows you to choose programmes that you wish to remind watching or record to the
external recorder. At the correct time, the TV will tune to the correct channel automatically to record even if the TV is in
Standby mode.
TV Guide may also be used to set timer programming event (p. 21).
Timer Programming can store up to 15 events.
For recording using Timer Programming, the TV must be either On or in standby. For reminders to be displayed, the
TV must be On.
No other channel can be selected while the recording of Timer Programming is in progress.
It may not be possible to record an encrypted programme (which is copy-protected).
When recording programmes to the external recorder, be sure to make the proper settings on the recorder connected
to the TV.
If a compatible recorder with Q-Link or similar technologies is connected to the TV (p. 62) and the [Link Settings]
(p. 32, 33) are correct, no setting of the recorder is required. Also read the manual of the recorder.
If the recorder is not compatible with Q-Link or similar technologies, set the timer of the recorder in addition to the
Timer Programming on the TV. For preparations of a recorder, read the manual of the recorder.
Recordings are always in standard definition composite video via SCART, even if the original programme is in high
definition.
Select the tuner you want to use (DVB or Analogue)
1
TV
Display the menu and select [Setup]
2
Select [Timer Programming]
3
Setup Menu
Timer Programming
Note
Check that the LED is orange. If not, timer programmes are not active or not stored.
Timer Programming reminder messages will remain displayed until one of the following occurs :
You press the OK button to view the programme or the EXIT button to cancel the reminder.
•
The timer programming event that the reminder is set for ends.
•
"!" identifies that any timer programming events have overlapped. [Ext Rec.] is given priority over [Reminder]. When
two or more [Ext Rec.] overlap, the first timer programming event starts and finishes as programmed. The next timer
programming event will then start.
2 minutes before the starting time, a reminder message appears if you are watching TV.
To remove the message and
•
start the programme
The recording of Timer Programming will automatically change to the programmed channel a few seconds before the
start time.
To stop recording of the timer programming event, it may be necessary to stop the recorder manually.
The recording of Timer Programming will be performed even if the TV is in Pause Live TV recording (p. 65). In this
case, the Pause Live TV will be cancelled.
Main Menu
Picture
Sound
Setup
1/2
Access
select
access
select
access
To cancel the Timer
•
Programming
43