On Screen Messages - Panasonic Viera TX-L32X5B Operating Instructions Manual

Problem
The LCD panel moves
slightly when it is
pushed with a finger
Clattered sound might
be heard
Overcurrent error
message appears
An error message
appears

On screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software version
.
Press OK to start update (may
take over 40 mins) or press
EXIT to ignore and you can
update when TV is in standby
Invalid operation - Please
check settings and
connections.
Invalid system time. Please
exit !
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
Max. number of timers already
set !
New channels found!
Press OK to update channel
list.
Press EXIT to ignore.
78
There is some flexibility around the panel to prevent damage to the panel.
The panel might move slightly when it is pushed with a finger, and clattered sound
might be heard. This is not a malfunction.
The connected USB device might cause this error. Remove the device and turn the
TV off with Mains power On / Off switch, then turn it on again.
Check foreign objects are not inside the USB port.
Follow the message's instructions.
If the problem persists, contact your local Panasonic dealer or the authorised
Service Centre.
[Shipping Condition] will erase all tuning data
Confirm correct operation.
Confirm correct operation.
The signal is weak. Check the aerial is plugged in properly. It may be
necessary to have an aerial installer check the signal and aerial alignment.
Reset channels. (p. 38)
The selected channel is locked in Child Lock (p. 45). You must enter the PIN
number before the channel will be displayed.
It is not possible to record from COMPONENT or HDMI. Connect the recorder
to the TV using a fully wired SCART cable for recording from the TV tuner.
Confirm Q-Link or VIERA Link settings
The selected feature on VIERA TOOLS is not available. Press the OK button
to view the demonstration to explain how to use it.
There is a new software available.
Check the Q-Link or VIERA Link connection and setting
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
Cannot get the time information. If there is no time displayed on the
Information banner, check the connection of the RF cable.
The maximum number of timer programming events is 15.
There may be new channels available.
This message will appear each time a change is made by the broadcasters.
This message can be deactivated by setting [New Channel Message] to Off in
[DVB Tuning Menu].
Selecting OK will perform [Update Channel List].
Actions
Meaning / Action
(p. 48)
(p. 60 - 63)
(p. 60 - 63)