Removing Interference / Changing Rf Output Channel; Checking The Settings After Auto-Setup - Panasonic Diga DMR-EH80VEB Quick Start Manual

Removing interference / Changing RF output channel

TV screen
The picture with interference
RF OUTPUT CHANNEL
DVD
CH:
21
SELECT
ENTER
RETURN
On-Screen Display
Test pattern indication
DVD display
Indication when the RF output
channel is 21 (example)
Indication after changing the RF
output channel to 31 (example)
RF OUTPUT CHANNEL
DVD
CH:
31
SELECT
ENTER
RETURN
Test pattern indication
The clear picture

Checking the settings after Auto-Setup

FUNCTIONS
DVD-RAM
Disc Protection Off
PLAYLISTS
DIRECT NAVIGATOR
FLEXIBLE REC
DV AUTO REC
TIMER RECORDING
VIDEO Plus+
SETUP
DISC MANAGEMENT
DUBBING
To Others Return
ENTER
RETURN
SETUP
Manual
Auto-Setup Restart
Download from TV
Tuning
Disc
Picture
Sound
Display
Download from TV Manual Tuning
Connection
Name Ch
Pos
Others
901 BBC1 22
BBC2
902 23
903 ITV 24
904 CH4 25
905 CH5 26
906
30
* * * *
907
SELECT
908
ENTER
909
RETURN
910
Delete
TV reception channels
In some cases, interference (lines or patterning) or a very poor picture
may appear on the TV when the DVD Recorder is connected. If this
happens, follow the steps below to change the video playback channel
(RF output channel) to remove the interference.
Select HDD or DVD.
Press the FUNCTIONS button for more than 5 seconds.
The RF output channel number is displayed on the DVD display.
Press the Numeric buttons or use the Channel (CH)
CH
button to select a channel number, which differs by 2
or 3 from the present channel number. (For example,
if the original channel number was 28, enter 31.)
Retune your TV until you receive the Test pattern. It
may be necessary to repeat steps above until you can
see the Test pattern clearly.
If using a Scart cable please see the note below.
Press ENTER to finish this setting.
Set the RF output channel of the DVD Recorder to [- -] (RF OFF) if the
DVD Recorder is connected to the TV via the 21-pin Scart cable.
Press
displayed on the DVD display.
Press channel select buttons CH or 0 to invoke [- -].
Confirm with ENTER.
Press FUNCTIONS to display the FUNCTIONS Menu.
Press
Press
Press
TV stations and confirm that all available TV stations have been set correctly.
If station name is [
The asterisks indicate that a station was found during Auto-Setup but has not
been named (due to a weak signal).
The stations in the list with asterisks will need to be named manually.
See page 95 of Operating Instructions.
If station name is [- - - -]:
The dashes represent unused channel positions.
You can set stations manually if desired.
See page 95 of Operating Instructions.
RETURN
Press RETURN to exit the On Screen Display.
Pos Name Ch
911
When the station names have not been set correctly, see page 96 of
912
913
Operating Instructions for details.
914
If no stations were found, confirm all connections of the DVD Recorder again
915
916
and restart the Auto-Setup. See page 97 of Operating Instructions for details.
917
918
919
920
HDD DVD
FUNCTIONS for about 5 seconds. The preset channel will be
...
21 68
(RF OFF)
to select [To Others] and then press ENTER.
to select SETUP and then press ENTER.
to select Manual and then press ENTER to display the list of tuned [ ]
]:
- 6 -
1
2 3
4 5 6
7 8 9
0