Component Video Out Terminal - Panasonic DMR-ES10EB Quick Setup Manual

DMR-ES10-EB_QSG-1.fm 3 ページ ２００５年２月２８日 月曜日 午後１時１７分
Connecting a television with AUDIO/VIDEO terminals and VCR
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
To the aerial
Television's rear panel
Splitter VHF/UHF
RF IN
Aerial
lead
Use a splitter if you
also want to connect
the aerial to your VCR.
VHF/UHF
RF IN
Connecting a television with S VIDEO or COMPONENT VIDEO terminals
AUDIO IN VIDEO S VIDEO
R L IN
Red White Yellow
Audio/Video
cable
Yellow
White
Red
S VIDEO OUT terminal
Connect to S VIDEO IN terminal on the television
through a S Video cable.
The S VIDEO OUT terminal achieves a more vivid
picture than the VIDEO OUT terminal. (Actual results
depend on the television.)
■ Component video output
Component signal outputs the colour difference signals (P
reproducing colours. If the television is compatible with progressive output, a high quality picture can be output because this unit's
component video output terminal outputs a progressive output signal (➔ page 42 of Operating Instructions).
RF coaxial lead
Yellow
White
Red
Audio/Video cable
Red White Yellow
You can also connect with the AV2 terminal
on this unit using the 21-pin Scart lead.
R L
AUDIO OUT VIDEO OUT
COMPONENT
IN VIDEO IN
Television's
rear panel
S Video cable
This unit's
rear panel
/P ) and luminance signal (Y) separately in order to achieve high fidelity in
B R
BE SURE TO READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 2 IN THE OPERATING INSTRUCTIONS
BEFORE CONNECTION.
To household mains socket
(AC 220-240 V, 50 Hz)
AUDIO IN VIDEO IN
R L
Red White Yellow
AC mains lead
Connect only after all other
connections are complete.
Audio/Video cable
Yellow
White
Red
VCR's rear panel
AUDIO IN VIDEO
R L IN
Red White Yellow
Audio/Video cable
Yellow
White
Red

COMPONENT VIDEO OUT terminal

Connect to COMPONENT VIDEO IN terminals on the
television through a video cable. These terminals can be
used for either interlace or progressive output
➔
( page 42 of Operating Instructions) and provide a
purer picture than the S VIDEO OUT terminal.
•
Connect to terminals of the same colour.
•
Video output from the component terminal will have no
colour during EXT LINK recordings. Use a fully wired 21-
pin Scart lead between the TV and the unit when viewing
external equipment picture through the AV2 terminal.
(➔ page 9 of Operating Instructions, Note to owners of
progressive compatible PAL system televisions)
- 3 -
This unit's rear panel
S VIDEO COMPONENT
IN VIDEO IN
Television's
rear panel
Video
cable
This unit's
rear panel