TG7100-7120FX(e-e).book Page 10 Thursday, August 10, 2006 10:32 AM
Preparation
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Symbols used in these
operating instructions
Symbol
Meaning
{j/OK} Press {j/OK}.
Proceed to the next operation.
i
10
Symbol
Meaning
" "
Select the words in quotations
shown on the display (e.g.,
"Handset Setup") by
pressing {^} or {V}.
Region settings
You can set the unit to use settings that
match your country (page 20). The display
language and other settings will change
accordingly.
Note:
L The display language only changes (to the
selected country's default setting) for the
handset used to select the region setting.
You must change the display language for
all other handsets separately.
Display language
16 display languages are available.
You can select
You can select "
"
", , "
", "
"Č Š
", , "
"
", , "
Š
"
", , "
"
", , "
"
", or
, or "
1
{j/OK}
2
Press {^} or {V} to select "Handset
Setup". i {>}
3
Press {^} or {V} to select "Display
Setup". i {>}
4
Press {^} or {V} to select "Select
Language". i {>}
5
Press {^} or {V} to select the desired
language. i {>} i {ih}
", , "
",
",
", ,
",
Š ", ,
", , "
",
".