Using The Time Alignment - Pioneer AVH-P6050DVD Operation Manual

Section
17 Digital Signal Processor
3 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 to –10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Touch STOP to stop the test tone out-
put.
Notes
! If needed, select speakers and adjust their 'ab-
solute' output levels. (Refer to Adjusting the
speaker output levels on page 78.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at SPEAKER LEVEL. Both provide
the same results.

Using the time alignment

Only when the multi-channel processor (e.g.,
DEQ-P7650/DEQ-P6600) is connected to this
unit, you can operate this function.
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Touch TIME ALIGNMENT on the DSP
function menu.
2 Touch any of the following touch panel
keys to select the time alignment.
! INITIAL – Initial time alignment (factory set-
ting)
! AUTO TA – Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on
page 83.)
80
En
! CUSTOM – Adjusted time alignment that
you can create for yourself
! OFF – Turn the time alignment off
! ADJUST – Adjust the time alignment as de-
sired
# You cannot select AUTO TA if auto TA and EQ
has not been carried out.
# You cannot select ADJUST when neither
FRONT-L nor FRONT-R is selected in POSITION.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in CUSTOM.
1 Touch TIME ALIGNMENT on the DSP
function menu and then touch ADJUST.
# You cannot select ADJUST when neither
FRONT-L nor FRONT-R is selected in POSITION.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order:
FRONT-L (front speaker left)—CENTER (center
speaker)—FRONT-R (front speaker right)—
REAR-R (rear speaker right)—REAR-L (rear
speaker left)—SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
at OFF. (Refer to Setting the speaker setting on
page 77.)
3 Touch c or d to adjust the distance be-
tween the selected speaker and the listen-
ing position.
Each time you touch c or d increases or de-
creases the distance. 0.0 to 500.0 [cm] is dis-
played as the distance is increased or
decreased.
4 Touch ESC to return to the playback dis-
play.