Pioneer DVR-310 Operating Instructions Manual page 28

Getting started
04
2 Press OPEN/CLOSE to open the disc tray.
3 Load a disc.
Load a disc with the label side facing up, using the disc
tray guide to align the disc (if you're loading a double-
sided DVD-Video disc, load it with the side you want to
play face down).
• If you want to play a DTS audio CD, please first read
the note on page 29.
4 Press PLAY to start playback.
• If you're playing a DVD-Video or Video CD, a disc
menu may appear when you start playback. Use the
(cursor) buttons and ENTER to navigate
DVD disc menus, and the number buttons and
ENTER for Video CD menus.
• See the following sections for more details on playing
specific kinds of discs.
5 To stop playback, press
6 When you've finished using the recorder, eject
the disc and switch the recorder back into standby.
• To open/close the disc tray, press
Remove the disc before putting the recorder into
standby.
STANDBY/ON to switch the recorder into
• Press
standby.
28
En
STOP.
OPEN/CLOSE.
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
Press to start playback.
PLAY
If RESUME is displayed on-screen, play-
back starts from the place last stopped.
Press to stop playback.
STOP
You can resume playback from the same
point by pressing
again to cancel the resume function.)
Pauses playback, or restarts playback
PAUSE
when paused.
Press to start scanning. Press repeatedly
REV SCAN FWD SCAN
to increase the scanning speed. (There are
four scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next chapter/title.
PREV NEXT
Except VR mode: During playback, enter a
chapter number then press ENTER to skip
directly to that chapter within the currently
playing title.
CLEAR On some discs, you can also use the num-
ber buttons to select numbered items in
the disc menu.
VR mode only: During playback, enter a
title number then press ENTER.
(Commercial skip) Each press skips for-
CM SKIP
ward 30 seconds. Use to a maximum of 4
mins.
During playback, press to start slow-
STEP/SLOW
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame in either direction.
Press to display the 'top' menu or menu of
a DVD-Video disc (these are often the
TOP MENU MENU
same).
Use the cursor buttons to navigate DVD-
Video disc menus; press ENTER to select
items.
ENTER
Press to return to the previous level of a
RETURN
DVD-Video disc menu.
PLAY. (Press STOP