Multi-Unit Operation; Operating Additional Units; Registering A Handset To A Base Unit - Panasonic KX-TG8070FX Operating Instructions Manual

TG8070-8090FX(e-e).book Page 27 Wednesday, August 1, 2007 9:26 AM

Operating additional units

Additional handsets
Up to 5 handsets can be registered to a single
base unit.
Important:
L The additional handset model recommended for
use with this unit is noted on page 4. If other
model handset is used, certain operations
(handset settings, base unit settings, etc.) may
not be available.
L Additional handsets will give you the freedom to,
for example, have an intercom call with another
handset while a third handset is on an outside
call.
Additional base units
Handsets can be registered to up to 4 base units,
allowing you to add additional base units and
extend the area in which your handset(s) can be
used. You need to select the desired base unit to
use the handset with (page 27).
Registering a handset to a
base unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example, w flashes
even when the handset is near the base unit),
register the handset.
1
Press and hold {x} on the base unit for about
5 seconds until a beep is heard.
L If all registered handsets start ringing, press
{x} to stop, then repeat this step.
L After a beep is heard, the rest of this
procedure must be completed within 1
minute.
2
{MENU} (right soft key) i r i {OK}
3
{^}/{V}: "Registration" i {OK}
4
{^}/{V}: "Register Handset" i {OK}
5
{^}/{V}: Select a base unit number. i {OK}
L This number is used by the handset as a
reference only.
L The registered base unit is indicated by "@".

Multi-unit Operation

6
"Enter PIN" is displayed. Enter the base unit
PIN (default: "0000"). i {OK}
L If you forget your PIN, consult your nearest
Panasonic service centre.
L When the handset has been registered
successfully, w will stop flashing. If the key
tone is turned on (page 16), a confirmation
tone will be heard.
Selecting a base unit
When a specific base unit is selected, the handset
will make and receive calls using that base unit
only. If the handset is out of range of that base unit,
no calls can be made.
1
{MENU} (right soft key) i r i {OK}
2
{^}/{V}: "Select Base" i {OK}
3
{^}/{V}: Select the desired base unit. i
{OK}
L The selected base unit is indicated by "t"
located on the left of the item on the display.
L The handset starts searching for the base
unit.
Deregistering a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored in the
base unit. This will allow the base unit to "forget"
the handset.
1
{MENU} (right soft key) i r i {OK}
2
{^}/{V}: "Registration" i {OK}
3
{^}/{V}: "Deregistration" i {OK}
4
Enter the base unit PIN (default: "0000"). i
{OK}
L If you forget your PIN, consult your nearest
Panasonic service centre.
L The numbers of all handsets registered to
the base unit are displayed.
L The handset you are using is indicated by
"t" located on the left of the item on the
display.
5
{^}/{V}: Select the handset(s) you want to
cancel. i {OK}
6
{YES} i {i}
Note:
L "Register!" is shown on the handset display
when you cancel registration.
27