On Screen Messages - Panasonic Viera TX-P42U30B Operating Instructions Manual

Problem
The TV does not switch
On
The TV goes into
Standby mode
The remote control
does not work or is
intermittent
Parts of the TV become
hot
An error message
appears

On screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to delete
this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software version
Press OK to start update (may
take over 40 mins) or press EXIT
to ignore and you can update
when TV is in standby
Invalid operation - Please check
settings and connections.
Invalid system time. Please exit !
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
Max. number of timers already
set !
74
•
Press and hold the standby On / Off switch on the remote control for about 1 second if
Power LED is red.
•
Check the mains lead is plugged into the socket.
•
The fuse in the mains plug may have blown. Replace it with one of an identical rating
(p. 4)
•
Auto power standby function is activated.
•
The TV enters Standby mode about 30 minutes after analogue broadcast ends.
•
Are the batteries installed correctly?
•
Has the TV been switched On?
•
The batteries may be running low. Replace them.
•
Point the remote control directly at the front of the TV (within about 7 m and a 30
degree angle of the front of the TV).
•
Situate the TV so that sunshine or other sources of bright light do not shine on the TV's
remote control signal receiver.
•
Temperature rises of parts of the front, top and rear panels will not pose any problems in
terms of performance or quality of the TV.
•
Follow the message's instructions.
•
If the problem persists, contact your local Panasonic dealer or the authorized Service
Centre.
•
[Shipping Condition] will erase all tuning data
•
Confirm correct operation.
•
Confirm correct operation.
•
The signal is weak. Check the aerial is plugged in properly. It may be necessary to
have an aerial installer check the signal and aerial alignment.
•
Reset channels.
•
The selected channel is locked in Child Lock (p. 43). You must enter the PIN number
before the channel will be displayed.
•
It is not possible to record from COMPONENT or HDMI. Connect the recorder to the
TV using a fully wired SCART cable for recording from the TV tuner.
•
Confirm Q-Link or VIERA Link settings
•
The selected feature on VIERA TOOLS is not available. Press the OK button to view
the demonstration to explain how to use it.
∗∗∗
.
•
There is a new software available.
•
Check the Q-Link or VIERA Link connection and setting
•
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
•
Cannot get the time information. If there is no time displayed on the Information
banner, check the connection of the RF cable.
•
The maximum number of timer programming events is 15.
Actions
(p. 9)
(p. 6)
Meaning / Action
(p. 36)
(p. 58 - 61)
(p. 47)
(p. 58 - 61)