Power On And Off - Panasonic PT-43LC14-K Operating Instructions Manual

Power ON and OFF

Turning the Power ON and OFF
Always be sure to follow the procedure given below to turn the projection display power ON and OFF.
• The lamp cooling fan will continue to operate for approximately 1 minute after the power is turned off. At the same time, the
POWER indicator will blink Red.
Do not disconnect the power cord from the outlet and do not open the circuit breaker (unless necessary)
while the cooling fan is still operating. Do not disconnect the power cord from the power outlet while the
power indicator blinks Red.
POWER
TV VCR DVD
DTV RCVR
DBS/CBL
TV/VIDEO A - ANTENNA - B
CH
Note:
• When the AC Cord is unplugged, the internal cooling fan stops op er at ing. In this case, the lamp will be insufficiently cooled and
will take a while to turn ON again.
Notes:
• If the POWER button is accidentally pressed during use, after power is turned back on, it may take a short period before the
lamp automatically comes on.
• After the unit is turned on, maximum picture brightness will be achieved in 5-10 minutes. This is normal.
22
POWER button/
POWER indicator
SAP
LIGHT
AUX
Power ON
Press POWER on projection display or Remote Control
to turn power on.
The Power Indicator blinks Green for about 10 seconds
and then turns solid Green.
Power OFF
Press POWER on projection display or Remote Control
to turn power off.
Power shuts off after a Black Screen is displayed for a
few seconds.
Note:
• If POWER is pressed during the Black Screen display,
Power is turned back on.
The Power Indicator blinks Red for about 1 minute and
then turns solid Red.
The Power Indicator
LED ACTION
Red Power – OFF (Standby mode)
Red blink Power – OFF (Now cooling)
Green Power – ON
Green blink Power – ON (Preparing to light lamp)