Charging The Battery - Philips Xenium User Manual

Charging the battery

A charger is supplied with the phone, in the box.
• Clip the battery on the phone.
• Plug the charger into the right socket at the base of the phone as shown
below.
• Plug the transformer unit into a mains AC power socket with easy access.
b
The symbol indicates the state of charge:
• During charging the 4 charge indicators change. If the first bar is dark, the battery already has
a 25% charge.
• The bars darken one after another during charging.
• When all 4 bars are dark the battery is fully charged. A minimum of 1hr40mn charging is
required to obtain a 90% charge with the Standard battery (capacity: 900 mAh). For the
maximum charge continue charging.
• When the battery is charged, remove the connector by pressing the release button on top
of the connector. Recharge the battery before it is totally flat.
L
NOTES:
1. You can turn your phone on and use it while it is charging.
2. The only way to turn the battery charger off is to unplug it from the mains outlet; for this reason use a
mains outlet with easy access.
3. You can connect the charger to an IT supply (Belgium only).
4. If the battery is completely flat, the battery icon will only reappear after 2 or 3 minutes of charging.
12
Initial start up procedure